MacDon 802 Bi-Directional Adapter - Manual (Page 21)

20
ATTACHING & DETACHING
DETACHING ADAPTER FROM TRACTOR
The adapter should be attached to tractor with the
header removed. For instruction on detaching
adapter and header from tractor, see page 28.
1. Raise the adapter. Stop engine and remove
key.
2. Swing the two adapter stands into support
position and install clevis pins, washers and
lynch pins at (A). Pin (A) is stored on top of
frame leg, each side. Extend foot and secure
with clevis pin, washer and lynch pin at (B).
Lower adapter onto stands.
3. Disconnect wiring harnesses (K) and (L).
Disconnect hydraulic hoses at ¾” couplers (H)
and ½” coupler (J). Leave header lift
couplers (G) connected. Plug or cap all
couplers to prevent hydraulic system
contamination.
4. For TV140 Tractor with NH Auxiliary Pump:
Disconnect sickle drive ¾” couplers (D).
5. For 9030 Tractor & TV140 Tractor with
MacDon Header Drive Pump: Disconnect
torque arm from channel (F) and rotate arm up
to clear adapter frame.
ADAPTER STANDS - SUPPORT POSITION
A
B
HYDRAULIC & ELECTRICAL
CONNECTIONS
(TV140 without AUX. PUMP SHOWN)
K
J
H
L
DISCONNECT TORQUE ARM – MD PUMP
F
D
DISCONNECT SICKLE DRIVE HOSES
TV140 with AUXILIARY PUMP
H
K