MacDon 802 Bi-Directional Adapter - Manual (Page 26)

25
ATTACHING & DETACHING
ATTACHING HEADER TO TRACTOR AND ADAPTER
(continued)
11. Depending on header type, connect from zero
to five hydraulic hoses between header and
adapter/tractor:
942 and 970 Series Headers - 5 hoses:
- reel drive pressure and return near right header
leg (R).
- reel lift (S) to TAN-EXTEND coupler at TV140
tractor. (To TAN-RETRACT on 9030 tractor.)
NOTE: Wrap reel lift hose (S) around adapter
hoses a couple of times to take up slack as
shown.
- conveyor drive pressure (M) near left header
leg.
- conveyor drive return (N) near left adapter
lower link.
920/930 Series Auger Headers - 3 hoses:
- reel drive pressure and return near right header
leg.
- reel drive auxiliary pressure near left header
leg.
910 Series Headers - no hoses.
12. Connect adapter wiring harness(es) to header
harness (T) near header left leg.
13. Connect driveline from adapter to header. Pull
back on spring loaded collar on end of yoke
and slide onto header shaft. Ensure collar locks
in place. Driveline chain remains attached at
hole in storage bracket (P).
14. Swing adapter stands back to the storage
position (F). Lower header and adapter to
ground.
ADAPTER STANDS – STORAGE POSITION
F
S
R
HEADER CONNECTIONS
T
N
P
M