MacDon 802 Bi-Directional Adapter - Manual (Page 9)

8
INITIAL SET-UP
PREPARING THE TRACTOR (continued)
3. Install the header control panel in cab:
TV140 TRACTOR
• Attach panel mount to left post using existing
hardware at (A). Drill a 1/8” (3 mm) hole and
install a #10 x ½ self-tapping screw at (B).
• Hang control panel on mount by engaging
screw heads in slots (C).
• Remove rubber grommet (D) near windshield
and slit it on the side to allow inserting panel
wiring harness.
• Position harness so plug is near electrical
connector.
• IMPORTANT: The auxiliary switch in cab must
be on to operate header control panel. Consult
your Tractor Operator’s Manual for location of
switch. If the tractor has no switch, ensure
there is power to the center pin on the 7-pin
connector when the key is ON.
NOTE: For Hydraulic Deck Shift Header, install
deck shift switch (shipped with the header) in
control panel as follows:
NOTE: If header has a serial tag with
production year ’00 or older, switch provided
with header will be too small for the hole in
control panel. Order switch 109063.
• Cut decal to expose third switch hole (G) in
panel.
• Push switch into hole and attach wires from
harness as shown. (The other loose plugs in
harness are not used in this application.)
• When header is attached, check function of
deck shift switch. Pressing left side of rocker
switch should shift decks to the left. If pressing
left side of rocker shifts decks to the right and
vice-versa, exchange positions of the two
green wires at the switch.
4. 9030 TRACTOR: Install brackets (A), provided
with the adapter, to reposition 9030 headlights
inboard of their original position.
NOTE: These brackets are not required on the
TV140 tractor.
DECK SHIFT SWITCH WIRING
(Hydraulic Deck Shift Headers)
INSTALL HEADLIGHT BRACKETS - 9030
INSTALL HEADER CONTROL PANEL
G
D
INSTALL PANEL MOUNT
A
B
C