MacDon 802 Bi-Directional Adapter - Manual (Page 16)

15
INITIAL SET-UP
PREPARING THE 741/742 HAY CONDITIONER
This conditioner is used with Model 942 Multi-Crop
and Model 970 series Harvest Headers. For Model
910 and 920 Series Headers, see page 12.
1. Attach hay conditioner forming shields to
conditioner as described in Header Operator's
Manual, except use top hole (A) as shown.
2. Move rear forming shield support brackets (D)
to second bolt from each end.
3.
Remove crop deflector from under adapter to
allow conditioner forming shield installation.
See page 10 for removal instructions.
Remove L-bracket from top of rubber strap
and attach rubber strap (E) to adapter frame
with 3/8 flange nut and washer supplied with
hay conditioner shield.
ATTACH RUBBER STRAPS
E
ATTACH REAR SUPPORTS
D
ATTACH FORMING SHIELDS AT TOP HOLE
A