MacDon 802 Bi-Directional Adapter - Manual (Page 8)

7
INITIAL SET-UP
PREPARING THE TRACTOR (continued)
3. Install the header control panel in cab:
9030 TRACTOR
• Pull the floor mat back. Remove the "knock-out"
plug from the 1 3/4 " (45 mm) hole (D) in the
floorboard. Hole is located 7" (180 mm) forward
of floor bend-line, and 13" (330 mm) from the
side of the console.
• Route the harness plug down through the hole.
Pull the plug down between the hoses to the
GREEN hydraulic couplers.
• Disassemble controller panel (E) from its
mounting bracket and cover. Remove clamp
from controller panel wiring harness and re-
orient harness to point toward hole (D). Replace
clamp. Position controller panel (E) even with
the top of console. Align front of panel with edge
of Rockshaft Position panel (F). Mark the
mounting hole position and drill two 1/8" (3 mm)
holes. Secure panel to console with two #10 x
1/2" self-tapping screws. Replace controller
panel cover. (Mounting bracket is used with
TV140 tractor only.)
• IMPORTANT: The auxiliary switch in cab must
be on to operate header control panel. Consult
your Tractor Operator’s Manual for location of
switch. If the tractor has no switch, ensure there
is power to the center pin on the 7-pin connector
when the key is ON.
NOTE: For Hydraulic Deck Shift Header, install
deck shift switch (shipped with the header) in
control panel as follows:
NOTE: If header has a serial tag with production
year ’00 or older, switch provided with header will
be too small for the hole in control panel. Order
switch 109063.
• Cut decal to expose third switch hole (G) in panel.
• Push switch into hole and attach wires from
harness as shown. (The other loose plugs in
harness are not used in this application.)
• When header is attached, check function of deck
shift switch. Pressing left side of rocker switch
should shift decks to the left. If pressing left side
of rocker shifts decks to the right and vice-versa,
exchange positions of the two green wires at the
switch.
DECK SHIFT SWITCH WIRING
(Hydraulic Deck Shift Headers)
INSTALL HEADER CONTROL PANEL (9030)
D
G
E
F