RKI Instruments GasWatch 2 Manual - Manual (Page 25)

GasWatch 2 Operator’s Manual Setting the Time • 20
Setting the Time
The GasWatch 2 allows you to set the time.
1. Make sure the GasWatch 2 is on and in Measuring Mode.
2. Press and hold the Air button, then press and hold the POWER/MODE
button to put the GasWatch 2 into Time Adjustment Mode. Release the
buttons when the word “SEt” appears on the LCD. Below “SEt”, the time
will be displayed and the hour in the time will be flashing.
3. Use the AIR button to increase the hour to the desired setting. If you
pass the desired setting, continue to increase the hour until it reaches
23 and then wraps around to 0, then set to the desired setting.
4. Press the POWER/MODE button to accept the hour setting. The minute
starts flashing.
5. Use the Air button to increase the minute setting to the desired setting.
6. Press the POWER/MODE button to accept the minute setting and
return to Measuring Mode.
Hour
Minute
Figure 5: LCD in Time Adjustment Mode
SEt
2 1 : 1 9
Battery
level