RKI Instruments GasWatch 2 Manual - Manual (Page 35)

GasWatch 2 Operator’s Manual Maintenance • 30
Figure 9: Removing the Spring Bars
2. Remove the spring bars from the old wristband.
The spring bar is protected by a hollow sleeve that is inserted in the
wristband. The hollow sleeve may remain inside the old wrist band
when the spring bar comes out. Be sure to remove the outer sleeve
from the wrist band.
3. Insert the hollow sleeves and spring bars into the new wristband.
4. Install the new wristband onto the unit with a spring bar tool.
Wristband
Use spring bar
tool to remove
spring bars.
AIR
POWER
MODE