SATEC C191HM - Manual (Page 12)

Chapter 1 Introduction 3
Measured Parameters
Note: Real-time values are measured over 1 cycle of fundamental frequency; Average
values are of 8, 16 or 32 real-time values
Parameter Dis- Output
play Com Analog Pulse Alarm
Average Amps, Volts, Frequency $ = setup via PC
# = setup via panel
Average RMS voltage per phase L-N √ √ #$ #$
Average RMS voltage per phase L-L √ √
Average RMS current per phase √ √ #$ #$
Average frequency √ √ #$ #$
Average neutral current √ √ #$ #$
Voltage & current unbalance √ √
Amps & Volt Demand Parameters
Ampere demand per phase √ #$
Volt demand per phase √ #$
Ampere maximum demand per phase √ √
Voltage maximum demand per phase √ √
Average Power Values
Average active power per phase √ √
Average reactive power per phase √ √
Average apparent power per phase √ √
Average total active power √ √ #$ #$
Average total reactive power √ √ #$ #$
Average total apparent power √ √ #$ #$
Average power factor per phase √ √
Average total power factor √ √ #$ #$
Power Demand Parameters
Active power accumulated demand √ #$ #$
Apparent power accumulated demand √ #$ #$
Active power demand √ #$
Active power sliding demand √ #$
Apparent power demand √ #$
Apparent power sliding demand √ #$
Active power predicted demand √ #$
Apparent power predicted demand √ #$
Active power maximum demand √ √
Apparent power maximum demand √ √
Energy Per Phase
Active energy import per phase √ √
Reactive energy import per phase √ √
Apparent energy per phase √ √
Total Energy
Total active energy import √ √ #$