SATEC C191HM - Manual (Page 50)

Chapter 5 Data Display 41
common measurements parameters.
Selecting Min/Max Measurements
Press the key. Use the up/down arrow keys to scroll through
Min/Max measurements.
Selecting Total Harmonic Measurements
Press the key until the THD/TDD LED is illuminated. Use the
up/down arrow keys to scroll through the different harmonic parameters.
Selecting Individual Voltage Harmonics Measurements
Press the key until the HARMONICS LED is illuminated and volts
LEDs at the right are lit. Use the up/down arrow keys to scroll through the
different harmonics readings.
Selecting Individual Current Harmonics Measurements
Press the key until the HARMONICS LED is illuminated and amps
LEDs at the right are lit. Use the up/down arrow keys to scroll through the
different harmonics readings.
Selecting Energy Measurements
Press the key. Use the up/down arrow keys to scroll through the
different energy readings.
Fast Reset of Accumulated Data
Select a display page where the data you want to reset is displayed. To reset:
• Min/Max log registers: select a Min/Max page from the Min/Max
measurements display (where a MAX or MIN round LED is illuminated).
• Ampere and volt maximum demands: select the ampere or volt maximum
demand page from the Min/Max measurements display (where a MAX
DMD LED is illuminated, and volts or amps LEDs at the right are lit).
• Power maximum demands: select the power maximum demand page from
the Min/Max measurements display (where a MAX DMD LED is illuminated,
and kVA/MVA and kW/MW LEDs at the right are lit).
• Total and phase energies: select the energy measurements display.
While holding the key, press and hold for about 5 seconds.
The displayed data is reset to zero.
MAX/MIN
ENERGY
SELECT ENTER
H/ESC
H/ESC
H/ESC