SPYPOINT WiFi - Manual (Page 13)

24 25
English
English
«MYSPYPOINT TM » MODE
Features: When the WiFi camera is connected to an
existing network, it can use mySPYPOINT
TM
service to host pictures. Therefore you can
quickly and easily access your photos from
anywhere using a Smartphone, a computer or
r
a tablet. Online configuration of the camera
is also possible via mySPYPOINT
TM website
(subscription required).
When configuring:
(Follow the steps on the camera screen)
Name of the N
camera
When entering the name of the camera, it is
possible to select up to 20 characters. Use
buttons
▲ and ▼ to change letters or numbers
and use buttons ◄ and ► to move from right to
left in the name. Press OK only when the name
is completed.
Test the
connection • Select an existing Wi-Fi network in the
screen of the camera.
• Enter the password of the network
; it is
possible to select up to 20 characters. Use
buttons
▲ and ▼ to change letters or numbers
and use buttons ◄ and ► to move from right to
left in the name. Press OK only when the name
is completed.
• Verify that all configuration settings are
correct.
• Confirm the configuration and test the
connection. When the connection test is
completed, press OK on the camera.
K
Camera setup/
Viewing photos It is possible to view photos, see the status of f
the camera and change its configuration via the
website www.myspypoint.com
(subscription
required)
REMOS TM TECHNOLOGY
This REMOS TM compatible camera benefits from wireless
capabilities and can be combined with:
• RC-1 ― Remote control (control of the camera remotely)
• MS-1 ― Motion sensor (triggers the camera remotely)
• IRB-W ― Infrared Booster (increases the lighting power)
Refer to the section SETTINGS for details
Note: The optional steel security box (SB-92) affects wireless
functionalities of products compatible with REMOS
TM technology.
REMOTE CONTROL
Synchronize
Remote control
:
Turn on the camera and leave the screen open
to the main menu. To synchronize the remote
control to the camera, press simultaneously the
ON and FN buttons. The red and green lights
will flash a few moments before turning on
and after, turning off. If the lights are flashing
constantly, it means that the synchronization
did not work. Try again.
Note: It is important that the «Remote» option
in the «Settings menu» is enabled.
Note: One remote control cannot control
several cameras simultaneously and a camera
cannot be controlled by several remote control.
Using the remote control :
Light features The red light flashes when the remote control
sends a signal. When the camera has received
this signal, the green light.
«ON»/«OFF»
buttons Allows to enable or disable remotely the
detection of the camera.