SPYPOINT WiFi - Manual (Page 14)

26 27
English
English
«CAMERA»
button Allows to take photos or videos (up to 500ft)
«FN» button Allows to enable or disable the Wi-Fi
network («Hunting
» mode only) or to start
a synchronization («Home Security » and
«mySPYPOINT TM » modes).
Note: To start a synchronization, the camera
must be in PHOTO
or VIDEO mode.
Note: When the Wi-Fi network is enabled, the
detection of the camera is disabled.
SOUND RECORDING
The SPYPOINT ® WiFi offers the possibility of recording the sound
in VIDEO mode. When the VIDEO mode is selected, the camera
automatically records the sound. The microphone is located on the
bottom of the camera. (See figure below).
DOWNLOADING TO A COMPUTER
To transfer or view pictures and videos using a computer, the camera
must be powered and set to the main menu before connecting the
USB cable (supplied) to the computer. Once the cable is plugged,
the computer recognizes the camera and installs the driver
automatically. Click on «My Computer» and select «Removable
Disk». Then click «DCIM» and «100SPYPT» to find the photos
and videos stored on the memory card.
The folder named «TRANSMIT» is a systems folder used by the
cellular transmission protocol, ignore this folder.
Note: Videos in .MP4 format require the use of a compatible
video player software such as VLC or QuickTime.
Taking the memory card out of the camera and inserting it into the
computer port will achieve the same results. If no SD card slot is
built into the computer, use a multi-card reader RD25-1
(sold separately, see OPTIONS).
TROUBLESHOOTING
No person or no animal on photos:
1. Rising sun or sunset can trigger the motion sensor. Camera must
be re-orientated.
2. At night, motion sensor may detect beyond range of the IR
illumination. Reduce the detection range of the camera («Settings
menu» / «Sensitivity»).
3. Small animals may cause unwanted detections. Reduce the
detection range and/or raise the camera.
4. Motion sensor may detect animals through foliage.
5. If a person/animal moves quickly, it may move out of the
camera’s field of view before the photo is taken. Move camera
further back or redirect camera.
6. Camera must be set on a stable and motionless object. e.g. large
tree.
Red light in front of the camera blinks:
• Camera is set in TEST mode.
• Camera is set in PHOTO or VIDEO mode. The red light in front of
the camera flashes for 60 seconds to allow the user to leave without
being photographed or recorded.
The camera screen turns off:
• The camera may be set to PHOTO or VIDEO mode and the screen
turns off in order to preserve battery life.
• The camera is left inactive for more than 2 minutes on the main
menu, it automatically resets itself to PHOTO mode and the screen
turns off.
• To return to the main screen, turn off the camera and turn in on
again.