SPYPOINT WiFi - Manual (Page 8)

14 15
English
English
Delay:
(10s/1min/3min/
5min/10min/
15min/30min)
Sets the time interval to wait between each
detection before the camera records the next
photo or video.
Additional setting: It is possible to decrease the
delay between detections to 10 seconds (instead
of 1 minute) by using the following procedure.
Note that the battery life will be affected.
Turn OFF the camera. Press and hold the ▲
button and turn the camera ON. «10sec enabled»
appears on the screen meaning the minimum
delay is now 10 seconds. To reset the camera
to 1 minute delay, follow the same procedure.
«10sec disabled» appears on the screen (see
figure below)
Video length:
(10s/30s/60s/90s)
Sets the recording time of video in VIDEO
mode.
Multi-shot:
(1/2/3/4/5/6
consecutive shots)
Allows the camera to take several consecutive
shots at each detection with a 10 second delay
between each photo.
10s enabled 10s disabled
Delay of 1 min. Delay of 10 sec.
Time Lapse:
(Off/10min/
30min/1h/2h)
Allows the camera to take pictures at regular
preset intervals. This option may be useful to get
pictures of animals outside the detection range
of the camera.
When the option «Time Lapse» is enabled:
• The «Delay» option is disabled.
• The «Multi-shot» option is disabled.
• The picture size is reduced to 800x600 in local
recording on the memory card.
Note: The «Time Lapse» recording option only
applies in PHOTO mode, not in VIDEO mode.
Work: Allows the user to set the period of operation of
the camera for each day of the week. The start
and stop time are the hours during which the
camera is in action and can record pictures or
videos.
Example: If the user selects a start time «15h»
and a stop time «19h», the camera will only
detect for that period of time and will stay
inactive for the remaining hours. Press OK and
use
▲ or ▼ to adjust the start time. Press OK
again to set the stop time. When the time is
properly set, press OK again to go back to other
settings. For an activation of 24 hours, the same
start and stop time must be entered (example:
00h as start time and 00h as stop time. These
hours are the default settings of your camera).
To turn off the camera, enter «--h» as start time
or end time. The camera is inactive for that day.
Note: The hours can be recorded over a 12 or 24
hours period. Refer to the «Time format» option
(00h means midnight)