SPYPOINT WiFi User Manual
Page 6
10
11
English
English
PHOTO
To take pictures. The PHOTO mode must be selected
by pressing OK; the test light in front of the camera (see
below) will fl ash for 60 seconds
to allow the user to leave the area
without being photographed.
A countdown is also displayed on the
screen during boot time.
VIDEO
To take videos. The VIDEO mode must be selected by
pressing OK; the test light in the front of the camera (see
above) will fl ash for 60 seconds to allow the operator
to leave the
area without being recorded.
A countdown is also displayed on the
screen during boot time.
SETTINGS
Sets the advanced options of the camera
(see «Settings Menu» for details).
TEST
Allows the user to test the detection system of the camera.
When the TEST mode is selected, no photo or video is
recorded. Pass in front of the camera from left to right. When the
camera detects motion, the test light blinks to indicate that the
camera would normally have saved a photo or video. If the system
does not detect movement, increase the detection range using the
option «Sensitivity» in the Settings menu ( «Low», «Medium» or
«High»). Realign the system if necessary.
Once you understand
how the device responds to detections, you can better adjust the
direction or the height of the camera.
Test light
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet)
In TEST mode, it is possible to take a picture by pressing the
OK button. The photo is saved and appears in the VIEW mode.
The TEST mode also provides information on:
1. The battery level
2. The used space on the memory card (as a percentage)
1.
2.