Rockwell Automation 842D-60131331BXA DeviceNet Encoder User Manual - Manual (Page 13)

Chapter
2
Installation
Chapter Objectives Chapter 2 provides the information that you need to install the 842D
DeviceNet encoder. In this chapter, you will read about the following:
• Cable connections.
• Installing the encoder.
Installing a Bulletin 842D
DeviceNet Encoder Selecting Cables
To connect the encoder to the DeviceNet network, you must select an
appropriate DeviceNet drop cable. A drop line connects a node, such
as an encoder, to the DeviceNet trunk cable. Use the following
information to select appropriate cables for each connection.
Bulletin 842D DeviceNet encoders are available with a single 5-pin
micro quick disconnect or two 5-pin quick disconnects (one male and
one female) for ‘daisy chain’ connections.
Pin configurations are per the DeviceNet specification as follows:
Figure 2.1 DeviceNet Micro Connections
Refer to the table below for recommended drop cables. .
Catalog Number Electrical Connection
842D-60131331BDA One 5-pin male micro QD
842D-60131331BXA Two 5-pin micro QDs (one male & one female)
Length Right Angle Micro Male to Straight Micro Female
1m 1485R-P1R5-F5
2m 1485R-P2R5-F5
3m 1485R-P3R5-F5
4m 1485R-P4R5-F5
5m 1485R-P5R5-F5
6m 1485R-P6R5-F5
3 4
5
2 1
3 4
1
5
2
Female Micro
Male Micro
1 Drain Bare
2 V+ Red
3 V- Black
4 CAN_H White
5 CAN_L Blue