Rockwell Automation 1407-CGCM Combination Generator Control Module - Manual (Page 106)

106 Rockwell Automation Publication 1407-UM001G-EN-P - April 2013
Chapter 5 CGCM Unit Startup
Recommended Equipment You need the following equipment to help in the startup of the CGCM unit.
Programming Terminal
A suitable programming terminal (typically a notebook personal computer) with
RSLinx, RSLogix 5000, and RSNetWorx for ControlNet software is required.
The programming terminal must be equipped with a suitable interface to support
communication with the Logix controller. A typical communication interface
can be a ControlNet network interface card (catalog number 1784-PCC) and its
cable.
Two-channel Chart Recorder or Other Suitable Data Recording
Method
A two-channel recorder or other suitable method is recommended for the
verification procedure. Chart recorder connections vary depending on the test
being performed.
ATTENTION: Electrostatic discharge can damage integrated circuits or
semiconductors. Follow these guidelines when you handle the module.
Touch a grounded object to discharge static potential.
• Wear an approved wrist strap-grounding device.
• Do not open the module or attempt to service internal components.
• If available, use a static safe workstation.
• When not in use, keep the module in its static shield bag.