Rockwell Automation 937CS-AITMP-DC1 Universal Temperature Converter Installation Instructions - Manual (Page 11)

10
Bul. 937
C Universal Temperature Converter Installation Instructions
FDT Interface
This manual describes Parameterization mode of the universal temperature converter using the
control panel. parameterization mode for the universal frequency converter is more convenient
with a PC using Field Device Tool (FDT) software.
Some specialized functions can only be selected using the FDT .
The FDT interface is the specification describing the standardized data exchange between devices and
control system or engineering or asset management tools. Examples include: PACTwareTM , FieldCare,
FactoryTalk AssetCentre, and Process Device Configuration. FDT frame software can be downloaded
from the web: www.pactware.com www.fdtgroup.org.
PACTwareTM is trademark of PACTware Consortium
Configuration tools
The Bul 937CS-AITMP-DC1 Universal Temperature Converter is parameterised using an FDT
configuration tool such as PACTwareTM.
Installation and connection with the device
Install the FDT software (ie PACTwareTM) on a PC.
Connect the PC and the Bul 937CS-AITMP-DC1 using the 937A-USBA USB cable. This cable can be
ordered as an accessory.
Pressing the plug in by force may damage the end devices.
Connect the cable with the jack plug to the USB interface on
the front panel of the Bul 937CS-AITMP-DC1. At the PC,
connect the USB connector to a free USB interface port.