Two plane balancing procedure overview, How to set up a two-plane procedure – Rockwell Automation 1441-DYN25-MBAL Balancing Extension Module for the Dynamix 2500 User Manual
Page 46

46
Rockwell Automation Publication 1441-UM004A-EN-P - May 2011
Chapter 2 Balancing Extension Module
Two Plane Balancing Procedure Overview
This is an overview of the steps you need to take when performing a two plane
balancing measurement.
1.
How to Set Up a Two-Plane Procedure on page 46
2.
Set-up Options Specific to Two-plane Balancing on page 47
.
3.
How to Perform Two-plane Balancing on page 50
.
4.
Perform the Initial Runs on page 50
5.
Two-plane Balancing with One Transducer on page 51
.
6.
Perform Trial Run 1 on Both Planes on page 53
.
7.
Perform Trial Run 2 on Both Planes on page 54
.
8.
Perform Correction Weight Runs on Both Planes on page 55
.
9.
Perform Trim Runs on both Planes on page 58
How to Set Up a Two-Plane Procedure
Specific differences exist between single and two-plane balancing measurement
field settings. Setup options specific to two-plane procedures are detailed below.
Single Plane Balancing on page 26
section for all other settings that apply to
both single and two-plane balancing.
Figure 1 - Balance Setup Screen with 2 Planes Selected.