Rockwell Automation 1441-DYN25-MBAL Balancing Extension Module for the Dynamix 2500 User Manual
Page 56
56
Rockwell Automation Publication 1441-UM004A-EN-P - May 2011
Chapter 2 Balancing Extension Module
The Correction Run – Plane 1 screen appears showing the amount of
residual unbalance on Plane 1 with the correction weights attached.
If two transducers are used for the balancing, both planes appear
simultaneously.
4.
Verify whether the amount of residual unbalance is within specifications.
5.
From the Correction Run – Plane 1 screen, press Enter.
6.
You are prompted to verify the transducer is attached to the bearing
nearest Plane 2.
7.
Verify the transducer and press OK.
The Correction Run – Plane 2 screen appears showing the amount of
residual unbalance on Plane 2 with the correction weights attached.The
Correction Run screen displays, showing the amount of residual unbalance
with the correction weight attached.
8.
Verify whether the amount of residual unbalance is within specifications.
9.
From the Correction Run – Plane 2 screen, press Enter.
You are prompted whether you wish to trim the residual unbalance.
If the vibration magnitude is greater than
this threshold, the magnitude bar is
colored red when taking a reading. The bar
turns green when the selected level of
imbalance is achieved.