Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Installation Instructions, PRIOR to Firmware rev. 3.0 - Manual (Page 44)

Publication 1404-IN007D-EN-P - October 2004
44 Powermonitor 3000
Figure 34 Connecting Powermonitor 3000 to Remote I/O Scanner
2
SHLD
1
2
SHLD
1
2
SHLD
1
2
SHLD
1
82 ohm
Terminating
Resistor
(See Note 2)
82 ohm
Terminating
Resistor
(See Note 2)
Blue
Shield
Clear
IBM Compatible
PC With R I/O
Interface Card
Or
PLC Processor/
PLC R I/O Scanner
Or
Or
SLC R I/O Scanner
ControlLogix R I/O Scanner
Notes:
1) 3-Device Network portrayed.
Up to 32 slave devices can
be connected per master
R I/O channel.
2) Terminating Resistors
must be connected
to each end of the
R I/O network. Omit the
terminating resistor(s)
if the device(s) already
are equipped with internal
terminating resistors.
R I/O
Powermonitor 3000 Device #3 (Last)
R I/O
Powermonitor 3000 Device #2
R I/O
Powermonitor 3000 Device #1