Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Installation Instructions, PRIOR to Firmware rev. 3.0 - Manual (Page 52)

Publication 1404-IN007D-EN-P - October 2004
52 Powermonitor 3000
•  - displays the optional communications status bitfield
as a hex number (0000 hex is normal for -232 and -RIO units,
and 9001 hex is normal for -DNT and -ENT units).
•  - displays the Display Module status bitfield as a hex
number. A non-zero value may indicate a problem, although a
non-zero value may appear if a Display Module is connected to
an operating Master Module.
•  - indicates the Display Module firmware revision.
•  - displays the current Date.
•  - displays the current Time.
•  - shows the status of the Form 4C relay.
•  - shows the status of the KYZ output.
•  - shows the status of Status Input 1.
•  - shows the accumulated value of Status Input
1 counter, since last cleared.
•  - shows the status of Status Input 2, since
last cleared.
•  - shows the accumulated value of Status Input
2 counter.
•  - displays the output word bitfield as a hex number.
Refer to the Powermonitor 3000 User Manual, publication
1404-UM001 for information on using the Display Module.
Calibration
To meet general operating requirements, regular recalibration is not
necessary.
For special customer requirements, contact your Rockwell Automation
representative for calibration or service information.