Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Installation Instructions, PRIOR to Firmware rev. 3.0 - Manual (Page 48)

Publication 1404-IN007D-EN-P - October 2004
48 Powermonitor 3000
Figure 39 Powermonitor 3000 Ethernet Network Example
Refer to the note at the beginning of Communication Wiring page 38.
Configuration options for optional Ethernet communications include
the IP (Internet Protocol) address, subnet mask, default gateway IP
address and protocol.
Defaults are:
•
IP address: 128.1.1.xxx where xxx is the Device ID assigned at
the factory in the range 1 to 254.
•
Subnet mask: 255.255.0.0
•
Default gateway IP address: 128.1.1.1
•
Protocol: CSP (PCCC)/CIP (EtherNet/IP) dual stack (Series A),
CIP (EtherNet/IP) (Series B)
LAN
Ethernet Switch
Powermonitor 3000
Master Module #1
Powermonitor 3000
Master Module #2
PC w/RSLinx and
RSPower 32 or
RSEnergyMetrix
PLC 5 Controller
ControlLogix Controller
SLC 500 Controller