Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Installation Instructions, PRIOR to Firmware rev. 3.0 - Manual (Page 53)

Publication 1404-IN007D-EN-P - October 2004
Powermonitor 3000 53
Cleaning Instructions
1. Turn off all electrical power supplied to the Master Module.
2. If necessary, clean the Master Module with a dry, anti-static,
lint-free cloth. Remove all dust and any obstructions from the
cooling air vents on the upper, lower, and ends of the module.
Ensure that the nameplate is clean and in good condition.
3. If necessary, clean the Display Module with a dry, anti-static,
lint-free cloth. Remove all dust and any foreign material(s) from
the exterior of the module. Ensure that the graphic front panel
overlay and back nameplate are clean and in good condition.
ATTENTION
Electrostatic discharge can damage integrated circuits
or semiconductors. Follow these guidelines when
you handle the module.
•
Touch a grounded object to discharge static
potential.
•
Wear an approved wrist strap grounding device.
•
Do not open the module or attempt to service
internal components.
•
If available, use a static safe work station.
•
When not in use, keep the module in its static
shield bag.
•
Disconnect and lock out all power sources and
short all current transformer secondaries before
servicing. Failure to comply with these
precautions can lead to personal injury or death,
property damage or economic loss.