Rockwell Automation 1769-SM2 Compact I/O DSI/Modbus Communication Module - Manual (Page 21)

Getting Started 1-9
This section is provided to help experienced users quickly start using the
1769-SM2 Compact I/O to DSI module. If you are unsure how to
complete a step, refer to the referenced chapter.
Quick Start
Step Action Refer to…
1 Review the safety precautions for the module. Throughout This Manual
2 Verify that the drive is properly installed. Drive User Manual
3 Install the module.
Verify that the controller is not powered. Connect the
module to the controller backplane bus. Then connect
the module to the drive(s) using communications cable
22-RJ45CBL-C20 or AK-U0-RJ45-TB2P terminal block
connectors and communications network wiring.
Chapter 2 ,
Installing the Module
4 Apply power to the module.
The module receives power from the controller. Apply
power to the controller. The MODULE indicator should
be green or flashing green. If it flashes red, there is a
problem. Refer to
Chapter 9 , Troubleshooting .
5 Configure the module for your application.
Set the following parameters for the module as required
by your application:
•
I/O configuration.
• Fault actions.
Chapter 3 ,
Configuring the Module
6 Apply power to the drive. Drive User Manual
7 Configure the controller to communicate with the
module. Depending on the type of
controller and 1769-SM2
operating mode:
•
Chapter 6 ,
MicroLogix 1500
Example Ladder
Programs
• Chapter 7 ,
CompactLogix
Example Ladder
Programs
•
Chapter 8 ,
ControlLogix w/
1769-ADN DeviceNet
Example Ladder
Program
8 Create a ladder logic program.
Use a programming tool such as RSLogix to create a
ladder logic program that enables you to:
• Control the module and connected drive.
•
Monitor or configure the drive using Explicit
Messages.