Rockwell Automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. - Manual (Page 11)

Communication Interface Module
Cat. No. 1784-KT2/C
Installation Data
11
Table 1
Required Cables for Connecting to a Programmable Controller
Use this cable: When connecting to:
1784-CP2 PLC-2 Family Programmable Controllers
1784-CP3 PLC-3 Family Programmable Controllers
1784-CP PLC-5 Family Programmable Controllers
1784-CP6 PLC-5/40 and PLC-5/60 Programmable Controllers (refer to
publication 1784-2.26)
1784-CP7 Adapter with
1784-CP Cable
PLC-5/40 and PLC-5/60 Programmable Controllers (refer to
publication 1784-2.29)
Connecting the 1784-KT2 to a PLC-2
To connect the 1784–KT2 to a PLC–2, follow these steps:
WARNING: To avoid personal injury, always disconnect the
ac power before making the cable connection.
1. Plug the 62–pin connector end of the 1784–CP2 cable into
the1784–KT2 and secure with captive screws.
2. Connect the other end of the 1784–CP2 cable into the PROGRAM
PANEL connector on the PLC–2.
3. Reinstall the ac power cord and turn on the computer.
Figure 1 shows cable pinouts for the 1784–CP2 cable.