Rockwell Automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. User Manual
Page 3
Communication Interface Module
Cat. No. 1784-KT2/C
Installation Data
3
Allen-Bradley publication SGI–1.1 “Safety Guidelines for the Application,
Installation and Maintenance of Solid State Control” (available from your
local Allen-Bradley office) describes some important differences between
solid–state equipment and electromechanical devices which should be
taken into consideration when applying products such as those described in
this publication.
Reproduction of the contents of this copyrighted publication, in whole or
in part, without written permission of Allen-Bradley Company, Inc. is
prohibited.
WARNING: With any complex communication system you
need to identify potential application–related communication
problems and make provisions in the system design to prevent
hazardous or undesired consequences if a problem occurs.
These problems include, but are not necessarily limited to, the
possibility of:
unexpected loss of communication
erroneous or incomplete data being supplied to the network
and passed on to your application
WARNING: The following provides information for
Allen-Bradley Industrial Computer and Communication Group
(ICCG) products that have been verified to meet the
Electromagnetic Interference (EMI) requirements of the Federal
Communication Commission (FCC) and the Canadian
Department of Communications for use in a commercial
environment:
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.