Rockwell Automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. - Manual (Page 17)

Communication Interface Module
Cat. No. 1784-KT2/C
Installation Data
17
The following sections describe how to start the diagnostic program from
the:
backup copy of the Options and Diagnostics diskette
OR
hard disk
You are not required to start the diagnostic program from both the backup
copy of the Options and Diagnostics diskette and the hard disk.
If you plan to start the diagnostic program from the hard disk, turn to the
section “Starting Up from a Hard Disk” later in this document.
Starting Up from the Options and Diagnostics Diskette
Important: Before starting the diagnostic program from the backup copy
of the Options and Diagnostics diskette, read the following:
Do not remove the backup copy of the Options and Diagnostics diskette
while the diagnostic program is running. The diagnostic program cannot
write test results to the output file if the diskette is not in the floppy
drive.
Make sure the write protection switch on the Options and Diagnostics
diskette is off when the diagnostic program is running. The diagnostic
program cannot write test results to the output file if the write protection
switch is on.
Always exit the diagnostic program through the “exit” menu to avoid
losing the output file.
To start the diagnostic program from the backup copy of the Options and
Diagnostics diskette, follow the steps below:
1. Turn on your computer.
2. When the prompt appears, insert the backup copy of the Options and
Diagnostics diskette.
3. Select the directory containing the diagnostic program by typing:
a: [ENTER]
When the prompt appears, type:
cd a:\ [ENTER]