Rockwell Automation 1784-PCIC ControlNet PCI Communication Interface Card Installation Instructions User Manual
Page 9
Install the 1784-PCIC or 1784-PCICS Communication Interface Card 1-5
Publication 1784-IN003D-EN-P - January 2006
To install the card, you need to:
•
access the computer’s expansion slots.
•
insert the card into the computer.
Access the Computer’s PCI Local Bus Expansion Slots
To install the card, you must access the computer’s PCI local bus expansion slots.
Follow these general steps, or refer to your computer’s user guide for further
instructions.
1. Shut down the host computer.
2. Remove the computer’s cover.
3. Select a vacant PCI local bus expansion slot.
4. Loosen the screw (if present) on the back (rear bracket) of the computer.
5. Remove the slot’s expansion cover.
IMPORTANT
The card’s dimensions are shown below.
4.2 in.
10.7 cm
6.5 in.
16.5 cm
31474-M