Rockwell Automation 1756-M02AS Motion Module Installation Instructions - Manual (Page 9)

SSI Servo Module 9
Publication 1756-IN595A-EN-P - March 2004
Connect the wires as shown below.
Figure 5 Connecting to Spring Clamp and Cage Clamp RTBs
Spring Clamp RTB Cage Clamp RTB
20860-M
20859-M
1. Strip 7/16 inch (11mm) maximum
length of wire.
2. Insert the screwdriver into the
inner hole of the RTB.
3. Insert the wire into the
open terminal and
remove the screwdriver.
1. Strip 3/8 inch (9.5mm) maximum
length of wire.
2. Insert the wire into the open terminal.
3. Turn the screw clockwise to close the
terminal on the wire.