Wiring the smartguard 600 controller – Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers Installation User Manual
Page 12
12 SmartGuard 600 Controllers
Publication 1752-IN001C-EN-P - January 2009
Power Supply Connections
Wiring the SmartGuard 600 Controller
See
for appropriate wire size and torque specifications.
Controller Terminal Descriptions
Terminal Designation
Description
V0
Power terminal for internal circuit (logic).
G0
Power terminal for internal circuit (logic).
V1
Power terminal for input circuits and test outputs.
G1
Power terminal for input circuits and test outputs.
V2
Power terminal for safety outputs.
G2
Power terminal for safety outputs.
IN0…IN15
Terminals for safety inputs.
T0…T3
These are test output terminals that can provide pulse test sources for safety
inputs IN0...IN15. T3 can also support wire off detection and burned out bulb
detection for a load such as a muting lamp.
OUT0…OUT7
Terminals for safety outputs.
WARNING
If you connect or disconnect wiring while the field-side power is applied, an electrical arc
can occur. This could cause an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
+ -
+ -
+ -