Making communication connections – Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers Installation User Manual
Page 15
SmartGuard 600 Controllers 15
Publication 1752-IN001C-EN-P - January 2009
Output Device Wiring
Making Communication Connections
You can configure the network and controller on the DeviceNet network by using a
1784-PCD card inside your personal computer and RSNetWorx for DeviceNet
software. You can also configure the network and controller by using the
controller’s USB port and RSNetWorx for DeviceNet software.
In addition, you can communicate via the EtherNet/IP network. The EtherNet/IP
address and subnet mask are configured with the RSLinx module configuration. The
1752-L24BBBE controller is shipped with BOOTP enabled for setting the
IP Address.
See
for details.
WARNING
Do not connect or disconnect the communication cable with power applied to this
controller or any device on the network, because an electrical arc can occur. This could
cause an explosion in hazardous location installations. Be sure that power is removed or
the area is nonhazardous before proceeding.
SmartGuard
600 Controller
V2
G2
0.5 A Max
OUTx
24V DC
Load