Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM - Manual (Page 53)

Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014 43
Configure the Module Using RSLogix 5000 Software Chapter 6
Download Your
Configuration After you write configuration for your module, the module does not use this
configuration until you download it to the owner-controller. The download
transfers the entire program to the controller, overwriting any existing program.
Download module configuration as shown below:
Depending on your application, a variety of RSLogix 5000 software screens may
appear to choose a path to your ControlLogix controller and to verify the
download. Navigate those screens as best fits your application.
This completes the download process.
Edit Your Configuration After you have set configuration for a module, you can review and change your
choices. You can change configuration data and download it to the controller
while online. This is called dynamic reconfiguration.
For the 1732E-OB8M8SR, you can do the following
through the Configuration tab:
A. Set the Output State during Program Mode and
Fault Mode for Points 0…7.
B. Set the Fault Duration and Fault Final State for
Points 0…7.
Grayed out unless Hold Duration is something
other than “Forever”.
C. Click OK to close the Module Properties dialog
and download your configuration, or
D. Click Help to access the RSLogix 5000 software
Add-On Profile help for descriptions of tabs that
are not required for setting up your module.
For more information on Output States, see Configurable
Point-Level Output Fault States on
page 61 .
1732E-OB8M8SR Configuration Tab
A. Click here to see the
pull-down menu.
B. Click download.