Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM - Manual (Page 54)

44 Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014
Chapter 6 Configure the Module Using RSLogix 5000 Software
Your freedom to change some configurable features, though, depends on whether
the controller is in Remote Run Mode or Program Mode.
The editing process begins on the main page of RSLogix 5000 software:
The General tab of the Module Properties dialog appears.
Click the tab of the page that you want to view or reconfigure and make any
appropriate changes, as shown in the example.
IMPORTANT Although you can change configuration while online, you
must go offline to add or delete modules from the project.
A. Right-click the module.
B. Select Properties.
The Internet Protocol tab is grayed out if you are offline.
Through this tab, you can do the following:
A. Specify Internet Protocol Settings. This allows you to
set manual or automatic configuration for your IP
settings.
B. To manually configure, specify IP Settings
Configuration by providing the following information:
- Physical Module IP address
- Subnet Mask
- Gateway Address
- Domain Name
- Host Name
- Primary and Secondary DNS Server
C. If you make changes in Step A or Step B, then click
Set. Changes will not take effect until you reset the
module or cycle the power to the module.
D. Click OK to close the Module Properties dialog and
download your configuration, or
E. Click Port Configuration tab to go to the next screen.