Rockwell Automation 1766-L32xxx MicroLogix 1400 Programmable Controllers Installation Instructions - Manual (Page 16)

16 MicroLogix 1400 Programmable Controllers
Publication 1766-IN001C-EN-P - October 2009
2. Holding the controller, pry downward on the latch until the latch locks in the open
position.
3. Repeat steps 1 and 2 for the second DIN rail latch.
4. Unhook the top of the DIN rail slot from the rail.
Panel Mounting
Mount to panel using #8 or M4 screws. Follow these steps to install your controller using
mounting screws.
1. Remove the mounting template from inside the back cover of this document.
2. Secure the template to the mounting surface. Make sure your controller is spaced
properly (see Controller Spacing on page 14 for more information).
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the controller.
6. Leave the protective debris strip
in place until you are finished
wiring the controller and any
other devices
ESC
OK
Open Closed 44519
44520
ESC
OK
Mounting Template
44521