Rockwell Automation 1766-L32xxx MicroLogix 1400 Programmable Controllers Installation Instructions - Manual (Page 23)

MicroLogix 1400 Programmable Controllers 23
Publication 1766-IN001C-EN-P - October 2009
Wiring Recommendation
When wiring without spade lugs, keep the finger-safe covers in place. Loosen the terminal
screw and route the wires through the opening in the finger-safe cover. Tighten the terminal
screw, making sure the pressure plate secures the wire.
ATTENTION Be careful when stripping wires. Wire fragments that fall into the controller
could cause damage. Once wiring is complete, be sure the controller is free of
all metal fragments before removing the protective debris strip. Failure to
remove the strip before operating can cause overheating.
Finger-safe cover
44527