Rockwell Automation 1757-FFLDC4 ControlNet Foundation Fieldbus Linking Device Installation Instructions - Manual (Page 8)

8 ControlNet Foundation Fieldbus Linking Device
Publication 1757-IN022B-EN-P - August 2009
Set the ControlNet Node Address
Use a small screwdriver to set the module’s ControlNet node address
switches.
WARNING
When you change switch settings while power is on, an electrical arc can
occur. This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
TIP
You can select an address from 01…99. 00 is an invalid ControlNet
network address.
1
2 3 4
5
6
78 9
0
1
2 3 4
5
6
78 9
0
10’s digit
1’s digit
44418
Example shows ControlNet node
address switches set to 15.