Rockwell Automation 1770-KF3 DH-485 Communication Interface User Manual - Manual (Page 26)

Configuring the KF3
Chapter 3
3Ć3
Configuration Steps
Entering Configuration Mode
1. Press the View button to enter configuration mode. The first
parameter number will be displayed on the left, with its current
setting on the right.
The KF3 continues to communicate while in configuration mode.
Changes in configuration do not affect operation until they are saved
and the module returns to run mode.
Configuring
2. Each time you press the View button, the parameter number in the
left display advances, and the parameter’s current setting appears in
the right (data) display.
Press the View button as often as necessary or hold it down until the
desired parameter is reached.
3. Once the desired parameter is displayed, press the Data button to
cycle through the available settings.
4. When you have reached the desired data setting, you can either save
the setting and exit configuration mode, or move on to configure the
next parameter.
To continue configuration, press the View button until the next
parameter you wish to change appears in the display. Use the Data
button to modify its setting.
Save and Exit
5. To save the new data and exit configuration mode, press the View
and Exit buttons simultaneously. The parameters you have changed
will be saved in nonvolatile memory. If the save is successful, each
display will show three dashes (see Figure 3.2) for a period of
two seconds. When the module returns to run mode, the new
configuration takes effect immediately, and the displays turn off.
If you press View and Exit simultaneously while in either menu, all
parameters in both menus will be saved and the module will return to
run mode.