Rockwell Automation 1770-KF3 DH-485 Communication Interface User Manual - Manual (Page 53)

Diagnostic Command Support
Appendix B
BĆ5
Table B.C
Diagnostic Status Reply for KF3
Byte Description Status Reply (hex)
1 Mode/Status byte 00 (No Modes)
2 Interface/Processor Type
Bits 0Ć3: Interface type
(E = Extended)
Bits 4Ć7: Processor type
(F = Computer)
FE
3 Extended Interface Type 2C
4 Not Used
5 Series/Revision
Bits 0Ć4:
Bits 5Ć7:
0 = Revision A
1 = Revision B, etc.
0 = Series A
1 = Series B, etc.
6Ć16 Bulletin Name = (ASCII) 1770ĆKF3"
17Ć24 ProductĆspecific Information 0
This command resets the diagnostic counters in the node interface module.
Figure B.7
Diagnostic Counter Reset Command Format
CMD
06
STS TNS FNC
07
1 byte 1 byte 2 bytes 1 byte
Figure B.8
Diagnostic Counter Reset Reply Format
CMD
46
STS TNS
1 byte 1 byte 2 bytes
Diagnostic Counter Reset