Rockwell Automation 1794-ASB/E Remote I/O Adapter Module User Manual - Manual (Page 5)

Summary of Changes
Publication 1794ĆUM009D-EN-P - April 2004
Summary of Changes
The information below summarizes the changes to the Remote I/O
Adapter User Manual, publication 1794-UM009D–EN–P, since the
last release.
The series E adapter is capable of recognizing the safe state data for
the FLEX Integra analog modules, and allows use of 32 point FLEX
I/O modules. You must use a series D or later adapter when using
FLEX Integra analog modules in your system.
The following new information is included in this version of the
publication:
Corrected Switch Positions
Switch positions on S! and S2 were incorrectly identified in the
previous version of this publication. Corrections have been made on
page 2–11 of Chapter 2.
Additional FLEX I/O Modules
New modules available since the last version of this publication have
been added.
Change Bars
The areas in this manual which are different from previous editions
are marked with change bars (as shown to the right of this paragraph)
to indicate the addition of new or revised information.
NewInformation