Rockwell Automation AutoMax Enhanced Ladder Editor User Manual
Rockwell Automation Equipment
Advertising
Table of contents
Document Outline
- J2-3093-3, AutoMax Ladder Language Editor Instruction Manual
- Preface
- Table of Contents
- 1.0 - Getting Familiar with the Editor
- 1.1 Overview of the AutoMax Ladder Editor Window
- 1.2 Opening Programs
- 1.3 Closing Program
- 1.4 Saving Programs
- 1.5 Saving Programs Automatically As You Work
- 1.6 Displaying a Program in Multiple Windows
- 1.7 Editing Different Parts of the Same Program Using Split Windows
- 1.8 Editing Multiple Programs
- 1.9 Displaying/Hiding Revision Marks While Editing Programs Offline
- 1.10 About Program Properties
- 1.11 About Program Execution
- 1.12 Running and Stopping Ladder Programs
- 1.13 Exiting the Ladder Editor
- 2.0 - Editing Programs
- 2.1 Starting a Rung
- 2.2 Selecting Rungs
- 2.3 Entering Rung Descriptions
- 2.4 Inserting Instructions into a Rung
- 2.5 Connecting Instructions (Drawing Wires)
- 2.6 Connecting Multiple Instructions by Using the ENO Output Bit
- 2.7 Selecting Instructions
- 2.8 About Instruction Properties
- 2.9 Changing an Instruction Type
- 2.10 Assigning Variable and Constants to Ladder Instruction Parameters
- 2.11 Entering Variable Descriptions
- 2.12 Using Variable Smart-Matching
- 2.13 Selecting Variable Names
- 2.14 Changing a Variable's Data Type
- 2.15 Changing a Variable's Scope
- 3.0 - Printing Programs
- 3.1 What Is Included in a Printed Copy of a Program
- 3.2 Setting Print Options
- 3.3 Defining the Page Setup
- 3.4 How a Rung is Printed To Fit on a Single Page
- 3.5 Inserting and Deleting Page Breaks
- 3.6 Printing a Range of Rungs
- 3.7 Displaying and Printing Coils as Right-Justified
- 3.8 Printing Multiple Copies of Programs
- 4.0 - Verifying Programs
- 5.0 - Editing Programs Online
- 5.1 About the States of Online Programs
- 5.2 Monitoring an Online Ladder Program
- 5.3 Pausing the Edito
- 5.4 About Power Flow
- 5.5 Monitoring Data in an Online Program
- 5.6 Accepting Changes Made to Online Programs
- 5.7 Downloading Changes Made to an Online Program (Commit Online Changes)
- 5.8 Testing Programs (Test Mode)
- 5.9 About How Changes Made to Online Programs Are Verified
- 5.10 Viewing an Online Program as it Looked Before It Was Edited
- 5.11 Capturing the State of Logic in an Online Program
- 5.12 Setting and Forcing Variables in Ladder Programs
- 5.13 Viewing and Clearing Run-Time Errors
- A - Toolbars, Paletts, and the Status Bar
- B - Keyboard Shortcuts
- C - Using the Pre-Defined (Reserved) Ladder Language Variables
- D - Online Editing Memory Limits
- E - Rung Executing Order
- F - Converting Ladder Programs Created Using an Older Version of AutoMax
- G - Glossary
- Index
- Document Improvement Form
- Back Cover