Rockwell Automation 2755-G3-W_G6-W Scanner with Wedge Option - Manual (Page 30)

Setup Instructions
Chapter 4
4–6
After installing the keyboard wedge interface you
need to enable the scanner to operate in wedge mode.
If this is a first time installation you must enable
the scanner to operate in wedge mode.
To enable wedge mode, scan label CE and listen for
two short beeps.
CE Enable
Wedge Mode *
You now need to identify the type of terminal that the
wedge interface is connected to. Scan the appropriate
label below and listen for two short beeps.
First time installations require you to program the
scanner for use with the connected terminal.
CF
PC-AT *
PS/2 and 50/60/80
Allen-Bradley 6121
Allen-Bradley 1784-T50, -T60
Allen-Bradley 2706-DL40
Allen-Bradley 1784-T35 (AT mode)
Compaq 386, 286
1
2
CG
PC-XT
Allen-Bradley 6120, 2706-DL40
Allen-Bradley 1784-T35 (XT mode)
Compaq Deskpro
1
2
1 Can be used in AT or XT mode depending on the internal jumper. See DL40 User Manual.
2 Can be used in AT or XT mode depending on the DIP switch setting. See User Manual for 1784-T35.
Enabling
Wedge Mode
Selecting a
Terminal Type