Rockwell Automation 2755-G3-W_G6-W Scanner with Wedge Option - Manual (Page 36)

Setup Instructions
Chapter 4
4–12
Table 4.A (continued)
Scanner Default Settings
Symbologies
Code Options Default
EAN/JAN (8 or 13 digit) Disable
Enable with 2 or 5 Digit Supplements
Enable without 2 or 5 Digit Supplements Disable
Enable or Disable Transmission
Number System Chararacter Enable
Enable or Disable Transmission
of Check Digit Enable
Interleaved 2 of 5 Disable
Enable without Check Digit
Enable with Check Digit Disable
Minimum Length 2
Maximum Length 32
Standard 2 of 5 Enable or Disable Disable
Minimum Length 4
Maximum Length 32
Code 128 Enable or Disable Enable
Minimum Length 1
Maximum Length 32
Codabar Enable or Disable Disable
Enable or Disable Transmission
Number System Chararacter Disable
Minimum Length 1
Maximum Length 32
To reset the scanner to the factory default settings
(listed in Table 4.A) scan label ZA.
ZA Reset to
Factory Defaults
Note: Scanning this label produces a bi-level tone.
Resetting
Factory Defaults