Rockwell Automation 2755-G3-W_G6-W Scanner with Wedge Option - Manual (Page 37)

A–B
5 Chapter
5–1
General Setup Parameters
This chapter describes parameters specific to the
operation of the scanner including:
•
System Status
•
Power Consumption
•
Beeper Operation
•
Capture Count
•
Spotter Beam
•
Autosense Mode
To set specific operating parameters, scan the
appropriate bar code labels in each section.
Note: Throughout this chapter, default settings for
parameters are flagged by an asterisk (* ).
The labels in this section allow you to examine the
configuration of your system.
To send a list of currently programmed parameters to
the display device, scan option ZB. A sample display
is shown on the top of the next page.
Note: Scanning ZB may interfere with your terminal
software, depending on your application.
ZB Display Configuration
Chapter
Objectives
System
Status