Install the iam/am power modules – Rockwell Automation 2094-BMxx-M Kinetix 6200 and Kinetix 6500 IAM and AM Power Modules Installation Instructions User Manual
Page 7
Kinetix 6200 and Kinetix 6500 IAM and AM Power Modules 7
Rockwell Automation Publication 2094-IN011D-EN-P - August 2013
Install the IAM/AM Power Modules
This procedure assumes you have prepared your panel, mounted your Bulletin 2094 power rail,
and understand how to bond your system. For installation instructions regarding equipment and
accessories not included here, refer to the instructions that came with those products.
You can use Bulletin 2094 mounting brackets to mount the power rail or line interface module
(LIM) over the AC line filter. Refer to the 2094 Mounting Brackets Installation Instructions,
publicat
IN008
, when using mounting brackets with your Kinetix 6200 and
Kinetix 6500 drive system.
The Bulletin 2094 power rail comes in lengths to support one IAM module and up to seven
additional AM/IPIM modules, or up to six additional AM/IPIM modules and one shunt
module. The connector pins for each slot are covered by a protective cover. The cover is designed
to protect the pins from damage and make sure that no foreign objects lodge between the pins
during installation. Refer to the Kinetix 6000 Power Rail Installation Instructions, publication
when installing your power rail.
SHOCK HAZARD: To avoid hazard of electrical shock, perform all mounting and wiring of the
Bulletin 2094 power rail and drive modules prior to applying power. Once power is applied,
connector terminals can have voltage present even when not in use.
ATTENTION: Plan the installation of your system so that you can perform all cutting, drilling,
tapping, and welding with the system removed from the enclosure. Because the system is of
the open type construction, be careful to keep any metal debris from falling into it. Metal
debris or other foreign matter can become lodged in the circuitry and result in damage to
components.
ATTENTION: To avoid damage to the power rail during installation, do not remove the
protective covers until the module for each slot is ready for mounting.