Rockwell Automation 2755-G6-D Scanner with RS-232 Option - Manual (Page 27)

Setup Instructions
Chapter 4
4–3
Removing Interface Cable
At some point you may have to replace the interface
cable with another cable.
To remove the interface cable, follow these steps.
Do not remove the interface cable until host
device is turned off. Failure to do this could
result in damage to the scanner.
CAUTION:
!
1. Turn power to host device off.
2. Disconnect power supply from AC power source.
3. Disconnect scanner from host device.
4. Insert a straightened paper clip into the cable
release hole as shown in Figure 4.3.
5. Press down firmly on the paper clip to release the
retainer and gently pull the connector out of the
scanner.
Figure 4.3
Removing Interface Cable
Cable Release Hole