Rockwell Automation 2727-M7P20D1P1, -M7P20D1Q2,-M7P20D1Q3 MobileView Machine Terminal MT750 - Manual (Page 94)

Publication 2727-UM003D-EN-P
7-2 Maintenance and Troubleshooting
Handling the MobileView
MT750 Terminal The MobileView terminal is a high-quality device that is equipped
with state-of-the-art electronics.
To avoid malfunctions or damage through improper handling, follow
these instructions during operation.
ATTENTION
!
• Do not operate the terminal if the cable is
damaged or pinched. To avoid damaging the
cable, do not place the cable over or around
sharp objects.
• When the terminal is not in use, hang the
terminal in the mounting bracket or place inside
a cabinet or enclosure.
• To avoid dropping the terminal, do not set the
terminal on unstable surfaces and keep the cable
clear of high traffic areas.
• To avoid damaging the operating elements, do
not set the terminal on its operating side.
• If the terminal falls to the ground, test the
emergency stop switch and enabling switch, and
verify that the PC card cover closes properly
before operating machine/plant.
• Do not set the terminal near heat sources and
avoid direct sunlight.
• Avoid exposing the terminal to mechanical
vibrations, excessive dust, humidity or strong
magnetic fields.
• Use a soft, damp cloth with 50% water and 50%
isopropyl alcohol to clean the operating panel
and operating elements. Do not use solvents,
scouring agents, or scrubbing sponges.
• Prevent foreign objects or liquids from getting
into the terminal. Check the protective covers of
the device regularly. Make sure all screws are
firmly tightened and that the housing and cable
entrance is not damaged.
• Turn off the power supply before removing the
back cover of the MobileView terminal. When the
back cover is removed, the terminal is sensitive to
electrostatic discharge (ESD).
• If the terminal exhibits any defect, have the unit
thoroughly and fully tested by the manufacturer
or authorized repair dealer before operating
terminal again.