Rockwell Automation 9329 Drive Application Software Tension Control Gen. Units - Manual (Page 40)

FM – Tension Control
Drive Application Software – page 40 of 52
5.5.1.5 TrqMemKnifeBoostEnbl – In 5
Enter a Boolean application tag that is programmed to boost the torque reference
to the drive.
5.5.1.6 TrqMemKnifeBoostRf_Pct – In 6
Enter a real application tag that stores the Knife Boost Referefence. When
entering this value directly at least one digit after the decimal is required i.e.
RRR.R
5.5.2 Output Parameters
5.5.2.1 TrqRef_Pct – Ret 1
TrqRef_Pct is used in the Regulator routine when the section's Torque Memory is
enabled.
5.5.3 Default Tags used in Drive Application Software