Rockwell Automation 9329 Drive Application Software Tension Control Gen. Units - Manual (Page 6)

FM – Tension Control
Drive Application Software – page 6 of 52
1.0 Precautions
Class 1 LED Product
ATTENTION: Hazard of permanent eye damage exists when using optical transmission
equipment. This product emits intense light and invisible radiation. Do not look into
module ports or fiber optic cable connectors.
General Precautions
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD control procedures are
not followed. If you are not familiar with static control procedures, reference Allen Bradley
publication 8000-4.5.2, “Guarding Against Electrostatic Damage” or any other applicable
ESD protection handbook.
ATTENTION: An incorrectly applied or installed drive can result in component damage or
a reduction in product life. Wiring or application errors such as under sizing the motor,
incorrect or inadequate AC supply, or excessive surrounding air temperatures may result
in malfunction of the system.
ATTENTION: Only qualified personnel familiar with the PowerFlex 700S AC Drive and
associated machinery the products control should plan, program, configure, or implement
the installation, start-up and subsequent maintenance of the system / product. Failure to
comply may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on the bus
capacitors has discharged before performing any work on the drive. Measure the DC bus
voltage at the +DC & –DC terminals of the Power Terminal Block (refer to Chapter 1 in the
PowerFlex 700S User Manual for location). The voltage must be zero.
ATTENTION: Risk of injury or equipment damage exists. DPI or SCANport host products
must not be directly connected together via 1202 cables. Unpredictable behavior can
result if two or more devices are connected in this manner.
ATTENTION: Risk of injury or equipment damage exists. Parameters 365 [Encdr0 Loss
Cnfg] - 394 [VoltFdbkLossCnfg] let you determine the action of the drive in response to
operating anomalies. Precautions should be taken to ensure that the settings of these
parameters do not create hazards of injury or equipment damage.
ATTENTION: Risk of injury or equipment damage exists. Parameters 383 [SL CommLoss
Data] - 392 [NetLoss DPI Cnfg] let you determine the action of the drive if communications
are disrupted. You can set these parameters so the drive continues to run. Precautions
should be taken to ensure the settings of these parameters do not create hazards of injury
or equipment damage.