Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers - Manual (Page 10)

Accessory Mounting Brackets and Covers 10
The hard drive mounting brackets allow you to mount a 3.5 inch
drive in one of the drive bays of the 6180 computer chassis.
•
Mounting Bracket for 3.5 Inch Drives
(Catalog No. 6189-IB35BRKT for Series A and B)
Installation
To install a drive using the hard drive mounting bracket:
1. Secure the drive to the bracket with the four mounting screws.
Tighten screw to a torque of 6-8 in. lbs (.7-.9 N
Sm).
Mounting Screws (4)
3.5 Inch Drive
Bracket
Part No. 6189-IB35BRKT
2. Position the drive / bracket assembly into the chassis. Make sure
the hook on the bracket slide into the corresponding hole in the
chassis. Also make sure that the key on the end of the bracket is
inserted into the slot on the chassis front panel.
3. Secure the drive / bracket assembly to the chassis with the two
mounting screws. Tighten screw to a torque of 6-8 in. lbs (.7-.9
N
Sm).
3.5 Inch Hard Drive
Mounting Bracket