Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers - Manual (Page 6)

Accessory Mounting Brackets and Covers 6
2. Remove the back panel to the 6180 computer.
3. A shorter drive cable is provided with the mounting kit for
mounting in the upper bay. Connect the cable to the floppy drive
connector on the processor board (refer to the Processor Board
user manual if necessary) and the connector on the back of the
drive.
4. Position the accessory drive / bracket assembly into the chassis.
The edge of the bracket fits under the tab at the front of the
chassis.
Note: You may have to remove the side panel knockout (shown
below) if a side mounted drive was not previously installed.
Insert screwdriver into slot on knockouts and pry back and forth
on knockout to remove. Use a pliers to remove the center rib
between the two knockouts.
!
ATTENTION: If knockout is removed, carefully
remove any burrs or sharp edges. Failure to remove
sharp edges could result in personal injury.
5. Align the bracket and chassis mounting hole and secure the drive
/ bracket assembly with a mounting screw. Tighten screw to a
torque of 6-8 in. lbs (.7-.9 N
Sm).
Bracket Mounting Screw
Bracket with Drive
in Upper Bay
Cover Knockout
for Upper Bay Mounting of Drive
6. Install the back panel.
7. Apply power to the 6180 Computer and verify operation of the
drive. You may need to edit BIOS settings to recognize the drive
or to allow the operating system to detect the new hardware.