Rockwell Automation 6189 Accessory Mounting Brackets and Covers for 6180 Computers - Manual (Page 12)

Accessory Mounting Brackets and Covers 12
The solid state drive mounting brackets allow you to mount a 2.5
inch or solid state drive in one of the drive bays of the 6180
computer chassis.
•
Mounting Bracket for 2.5 Inch or Solid State Drives
(Catalog No. 6189-IBSDBRKT for Series A and B)
Installation
To install a drive using the solid state drive mounting bracket:
1. Secure the drive to the bracket with the four mounting screws.
Tighten screw to a torque of 6-8 in. lbs (.7-.9 N
Sm).
Mounting Screws (4)
Solid State Drive
Bracket
Part No. 6189-IBSDBRKT
Standoff
Important: If you are installing a 2.5 inch drive, you must remove
the four standoffs and mount the drive directly to the bracket. Use
the mounting screws provided with the drive.
2. Position the drive / bracket assembly into the chassis. Make sure
the hook on the bracket slides into the corresponding hole in the
chassis. Also make sure that the key on the end of the bracket is
inserted into the slot on the chassis front panel.
3. Secure the drive / bracket assembly to the chassis with the two
mounting screws. Tighten screw to a torque of 6-8 in. lbs (.7-.9
N
Sm).
2.5 Inch/Solid State Drive
Mounting Brackets